Idiomas disponibles
Idiomas disponibles
MT Focus 400
5. Route the flat cable from the new front panel through the hole in the hous-
ing, attach the new front panel to the housing.
Make sure the light pipe is correctly positioned.
6. Mount the tool holder.
7. Insert the flat cable into the connector, and close the connector by pressing
in the movable part using a small screwdriver.
Changing the display
1. Open the connector by folding the movable part up and forward, and care-
fully pull out the flat cable.
2. Disconnect the white connector by pulling straight up.
3. Remove the display.
Do not loose the spacers.
4. Make sure the four spacers are correctly positioned and put the new display
in position. The small pins at the bottom of the display should rest in the
holes of the bottom spacers.
5. Connect the white connector.
6. Insert the flat cable into the connector.
Make sure the cable runs under the small tabs at each side of the con-
nector
7. Close the connector by turning the movable part back inte position.
EN
© Atlas Copco Industrial Technique AB - 9836 791600 00
Service
19
