Idiomas disponibles
Idiomas disponibles
MT Focus 400
Service
Maintenance
Preventing ESD problems
The components inside the tool and controller are sensitive to electrostatic dis-
charge. To avoid future malfunction, make sure that service and maintenance is
carried out in an ESD approved work environment. The figure below shows an
example of an appropriate service work station.
Service recommendations
Overhaul and preventive maintenance is recommended at regular intervals. See
the Preventive maintenance section for detailed information regarding over-
haul of your tool and specific parts. If the machine is not working properly, it
should immediately be taken away for inspection. At the overhauls, all parts
should be cleaned accurately and defective or worn parts should be replaced.
Maintenance
There are certain general maintenance procedures you should perform to keep
your MicroTorque system clean and operating at its efficiency.
The system is a sophisticated instrument with many sensitive components.
A built-in service reminder can be configured in Tools Talk MT. When it is
time to perform service on the tool, a reminder is shown on the controller dis-
play.
Preventive Maintenance:
• The system should never be exposed to harsh environment with rapid tem-
perature changes or excessive dust.
• Never expose the system to excessive vibration or high humidity.
• Prevent overheating by use only in the permitted temperature range. Do not
cover tool or controller or power supply.
• Cleaning of the tool and controller should be done regularly, but not with
aggressive cleanser.
• Check wear of the bit regularly.
• Replace worn cables immediately.
Tools which have been opened by anyone else than Atlas Copco Industrial
Technique AB, will not be serviced.
Calibration and preventive maintenance is recommended at regular intervals
once per year or after maximum 1.000.000 tightenings depending on which oc-
curs sooner.
EN
© Atlas Copco Industrial Technique AB - 9836 791600 00
Service
17
