TREVIDEA GIRMI AP10 Manual De Uso página 12

Idiomas disponibles
  • ES

Idiomas disponibles

operation. Periodically check the condition of the filter, taking care to clean it or replace it if damaged. These
measures will preserve the life of the unit and improve the vacuum performance.
MAINTENANCE AND CLEANING
EMPTYING THE DUST CONTAINER. When the dust reaches the maximum level inside the container
(6), it is necessary to remove it. For emptying the container, follow the steps below:
- Press the release button to open the dust container (8) separating the container from the main body.
- Remove the filter (7) by pulling it toward you. Empty container (6) into trash and rinse it with tap water.
- Dry the container before installing it on the unit.
CAUTION: if operating on wet surfaces, always empty the container (6) at the end of the operation.
FILTER MAINTENANCE. It is recommended to periodically check the condition of the filter and if it is
dirty it should be cleaned as described in the following paragraph:
- Press the release button to open the dust container (8) and separate the container from the unit.
- Remove the filter (7) by pulling it toward you.
- To remove dust from the filter, use a vacuum cleaner or wash it with tap water, being careful not to break
the filter; it is recommended to always dry it completely before replacing it inside the container.
CAUTION: when the filter (7) runs out, contact an Authorized Service Center for replacing it.
CHARGING -
If the power adapter is damaged or get lost, contact an authorized service center; it is recommended not to use
other adapters which may damage the battery and impair the functionality of the appliance. If suction capacity
decreases, you should start charging the battery.
or charging, switch off the product by bringing the power button (2) to position "0", plug the adapter to the
power outlet and connect the pins to the socket on the bottom of the unit (4).
The LED charging indicator (2) lights up when the unit is properly connected to the adapter. It stays on until
the adapter is connected to the appliance, even when the battery is fully charged.
The following measures will preserve the battery life. When you first use the unit, fully charge the battery by
leaving the vacuum cleaner adapter connected for about 10 hours. Before recharge the unit, wait for the
battery is completely exhausted. When the unit was has not being used for a long time (approx. 2 months), it
is recommended to let it charge for about 10 hours before using it again. In any case, it is advisable to fully
deplete the battery before a recharge. When charging operation is finished, unplug the power adapter and
keep it in a dry place, taking care not to damage the power cord. If the appliance, even after a complete
recharge, works only if it is connected to the adapter, the battery could be no longer capable of delivering
power to the unit. In this case, contact an authorized service center.
TECHNICAL FEATURES
Power adaptor: IN AC 100-240V
Motor power 30W
Accessories: nozzle, brush and nozzle for liquids.
PORTUGUÊS: ADVERTÊNCIAS
As indicações seguintes são muito importantes no que se
refere à instalação, uso e manutenção deste aparelho;
conserve com cuidado este manual para eventuais futuras
consultas; utilize o aparelho apenas do modo indicado
neste manual de instruções; outro tipo de utilização
deverá considerar-se inadequado e perigoso; por isso, o
CAUTION: to recharge the unit, use only the supplied original adapter.
50/60Hz – OUT DC 8V – 200mA
~
11
loading

Este manual también es adecuado para:

Slx217c