Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
UNPACKING
1. Remove all packing materials. This includes the foam base and all adhesive tape holding the
accessories inside and outside.
2. Inspect and remove any remaining packaging, tape and printed material before turning on the water
dispenser.
Note: Allow the water dispenser to stand in an upright position for at least10 hours before turning on
the power.
Proper Location
• To ensure that your water dispenser works at the maximum efficiency it was designed for, you
should install it in a location where there is proper air circulation and electrical connections.
• The following are the recommended clearances around the water dispenser.
Sides 2"
(50mm)
Back 4"
(100mm)
• Do not install your water dispenser in any location that is not properly insulated or heated because
the unit is not designed to operate in room temperature below 55˚F / 13˚C. The water dispenser is
for indoor use only. Room temperature should not exceed 97° F / 36° C.
Note: The built-in thermostat maintains the hot and cold temperatures automatically. On the com-
pressor cooled water coolers the hot water temperature will be between 185˚- 201.2˚ F/ 85˚-
94˚ C and the cold water temperature will be between 39.2˚- 50˚ F/ 4˚-10˚ C.
• Select a suitable location for the unit on a hard even surface away from direct sunlight and heat
sources (e.g., radiators, baseboard heaters, cooking appliances, etc.)
Note: Hot and cold water will not be instantly available as the unit will need time to heat up and
cool down the water.
CAUTION: DO NOT plug in the water dispenser until water flows through both Hot and
Cold water faucets.
ASSEMBLY INSTRUCTIONS
Read carefully and understand all installation instructions before installing the water dispenser.
Installing Your Water Dispenser
Follow the steps below to install the water dispenser.
1. Remove the cap from the water bottle first. Lift up the water bottle and quickly place it into the
water guard. (The water bottle is not included.)
2. DO NOT plug in the water dispenser until you have checked that water flows out of both the red
and blue faucets when pressed. Never turn on the water dispenser without water in it. Doing so
may cause the unit to catch fire or malfunction.
3. Check that water flows out by pressing both the red and blue water release buttons one at a time.
4. Plug the power cord into an 115volt / 60 Hz outlet.
5. To activate the water heater and cooler, turn ON the red and blue switches on the back of the unit.
The hot & cold indicators in the front will be lit.
English
6
