Operating Instructions - Altrad Belle RPX 35/40 Manual Del Operador

• Take the compactor to where it is required.
Where it is necessary to use lifting equipment to position the compactor, make sure the lifting equipment has a WLL (Working
Load Limit) suitable for the compactors weight (see Technical Data section or the machine serial plate). Attach suitable chains
or slings ONLY to the lifting point (Item 4 of the Machine Description) on the top of the compactor.
• Moving the compactor using the integrated wheel kit
• Use the Fixed Steering Handle (Item 7) to tilt the machine backwards onto the integrated wheels (Item 11).
• Manouvre only on smooth, at, rm surfaces. These wheels are not designed for soft, uneven surfaces.
• To lower the machine off it's wheels - stand on the foot rest (Item 9) and allow the machine to lower using your body weight as a
counter balance.
CAUTION
• Having carried out the checks listed in the 'Pre Start' section, you may start the engine.
The Altrad Belle 'RPX' range of compactors are tted with a centrifugal clutch, this allows the engine to run at idle without driving
the gearbox.
As the engine speed is increased the clutch will engage and will drive the gearbox. For correct operation, the engine speed
should be set to maximum.
• Set the throttle to maximum and use the control handle for direction and to steer or turn the compactor.
The control handle has been designed so that when it is being used in reverse and the operator lets go for any reason, the
handle automatically moves into forward mode. This is a signi cant safety feature of the machine.
During normal operation you should not have to push the compactor but allow it to travel at its own pace.
The speed of travel will be determined by the condition of the surface being compacted.
Caution must be used when operating the compactor in reverse. Ensure that there are no obstructions or trip hazards when
operating in reverse.
If the surface to be compacted is on a slope, great care must be taken when controlling the compactor's direction of travel. If
necessary, use a suitable rope attached to the compactor at a low point on the chassis, to allow a helper to take part of the
compactor's weight. Work up and down a slope not across.
• Work the compactor over the surface in an organised pattern until the required compaction has been achieved.
Where there are a number of different layers to be compacted on top of each other, compact each layer individually.
• To stop the compactor vibrating, set the throttle to idle. To stop the engine refer to the relevant Start / Stop procedure.
CAUTION
CAUTION

Operating Instructions

NEVER leave the engine running whilst the machine is being manouvered on its wheels.
DO NOT operate the machine in reverse on an incline.
DO NOT operate in reverse up to an enclosed or restictive space.
DO NOT use on boggy, waterlogged ground as the compactor will sink and cause excessive loading to
the engine and drive system.
27