Idiomas disponibles
Idiomas disponibles
EN
LED light replacement instructions
Note: the LED light is set to be non replaceable by the user
and needs to be replaced by professionals.
Lighting parameters: 12V / 10W
1. Unplug the power plug.
2. Remove the aluminum alloy trim strip on the top of the
LED surface light source, and then remove the left and
right fixing screws.
Steps 1 and 2 are shown below.
3. Replace the spare LED light board.
4. Replace the aluminum alloy trim strip in turn.
8
Care and Cleaning
Always disconnect the appliance from the power supply
before any cleaning or maintenance.
The fridge and freezer sections should be cleaned using a
solution of bicarbonate of soda and lukewarm water. Do not
use abrasive products or detergents. After washing, rinse
and dry thoroughly.
Clean the shelves and balconies separately by hand with
a mild solution of washing up liquid and water. Do not put
them in the dishwasher.
If the appliance is not to be used for prolonged periods
of time, unplug and clean the appliance. The doors should
be left slightly ajar to prevent the formation of mildew and
unpleasant odors.
Defrosting
The product has a no frost system which is designed to
prevent the heavy build up of ice. Under normal use, there
should be no need to regularly defrost the freezer system.
Please note: If you are regularly finding a heavy build up of
ice, or pools of water, in the freezer section then it is likely
that the door is not sealing properly. This could be due to a
defective door seal or an incorrectly fitted, or overly heavy,
decor door. For more information see the troubleshooting
section about ice.
