Idiomas disponibles
Idiomas disponibles
B
Using the appliance
Conversions
Replacing the injectors
Burners can be adapted to different types of gas by fitting appropriate injectors. To do this, first
remove the top part of the burners with a spanner
) and install an injector corresponding to the type of gas and type of burner used. Tighten the
injector firmly.
After replacing the injectors, the burners must be adjusted as described in paragraph 9. The
technician must replace the seals of adjustment and preadjustment devices. A bag containing
the replacement injectors and labels may be included in the kit or is available from the
authorised service centre.
For reference, the injector table also shows the heat output of the burners, the diameter of the
injectors and the operating pressures for the different gas types.
20
B
A
. Then unscrew the injector
B
A
13
Fig.
EN
C
Cleaning and maintenance
Always ensure that the appliance is disconnected from
the power supply and the gas supply is turned off before
13
(fig.
cleaning.
For the hob
Regularly clean the hob, the cast-iron support grates, the
cast-iron burner caps
fig.
) with warm soapy water. Then rinse all the components
6
and dry them thoroughly. Never clean the elements while
they are still hot. Never use abrasive products. Do not allow
residues of vinegar, coffee, milk, salt water, lemon or tomato
juice remain in contact with cast-iron surfaces for extended
periods.
Useful information
and the burner crowns
C
C
T
AC
TC
6
Fig.
21
EN
(see
T
