Idiomas disponibles
Idiomas disponibles
c)
Disconnect the unit from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d)
Keep unused equipment out of the reach of children and out of the reach of
anyone unfamiliar with the unit or this instruction manual. These units is
dangerous in the hands of inexperienced users.
e)
Keep the unit in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
f)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
h)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
i)
Do not move, shift, or rotate the unit while in operation.
j)
Clean the unit regularly to prevent permanent dirt build-up.
k)
The unit is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
l)
Do not tamper with the unit to alter its performance or design.
m) Keep the unit away from sources of fire and heat.
n)
Do not block the ventilation openings of the unit!
o) Ensure that the power supply to the unit corresponds to that specified on the
identification plate!
p) The unit must be connected directly to a wall plug socket.
q) After delivery of the unit, wait 8 hours for the refrigerant used inside the unit
to stabilize before connecting to the mains.
r)
Do not install the unit close to equipment generating high temperatures/heat
(heaters, boilers) and do not install the unit in direct sunlight!
s)
Do not damage the refrigerant circuit.
t)
Do not allow the rear coils of the unit to come into contact with the wall surface.
u) CAUTION! The unit in its construction contains flammable substances! If the
unit is damaged, avoid contact with open flames, as well as the room in which
the instrumentation is located should be thoroughly ventilated!
v) Do not place the unit in the vicinity of flammable materials such as paper or
other materials.
w) Do not place heavy objects on the unit.
x)
There is a risk of children getting stuck inside the unit. Before storing the end-
of-life unit, cut off the wiring at the back of the unit and disable the door lock
so that children cannot get stuck inside the unit.
y) The unit is not designed to freeze food products.
