Benelli TORNADO NAKED TNT125 Manual Del Propietário página 138

To change the engine oil (with or wi-
thout oil lter cartridge replacement)
1. Place the vehicle on a lat surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it o .
3. Place an oil pan under the engine to col-
lect the used oil.
4. Remove the engine oil ller cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1 2
1. Engine oil drain bolt.
2. Gasket.
TIP
Skip steps 5–7 if the oil lter cartridge is
not being replaced.
5. Remove the cartridge of oil lter by re-
moving the screws and the relative cover.
2
1. Screws
2. Oil lter Cartridge cover
6. Apply a thin coat of clean engine oil to
the O-ring of the new oil lter cartridge.
6 - 11
Periodic maintenance and adjustment
TIP
1
Make sure that the O-ring is properly se-
ated.
7. Install the new oil lter cartridge, the
cover and the relative screws, and tighten
them to the speci ed torque.
Tightening torque:
Oil lter cartridge:
10 N·m
EN
6