Benelli TORNADO NAKED TNT125 Manual Del Propietário página 109

Instrument and control functions
Turn signal indicator lights "
" "
Each indicator light will ash when its cor-
responding turn signal lights are ashing.
EN
Neutral indicator light "N"
This indicator light comes on when the
transmission is in the neutral position.
3
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Engine trouble warning light "
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
system.
The electrical circuit of the warning light
can be checked by turning the key to" ".
The warning light should come on for a
few seconds, and then go o .
If the warning light does not come on ini-
tially when the key is turned to" ", or if
the warning light remains on, have a Be-
nelli dealer check the vehicle.
Tachometer
" and
The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Digital clock
Shows the time in hours and minutes.
Digital clock setting
Push and hold the menu switch "SELECT"
"
for 3 seconds to enter the setting mode
"TOTAL KM".
Press and hold down the "SELECT" button
for 3 seconds until the reading begins to
lash.
Adjust the hour by pressing the"RESET"
"
button.
Press the "SELECT" button to pass on to
adjust the minutes. Adjust the minutes by
pressing the "RESET" button.
Press the "SELECT" button again to quit.
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the "E" reserve area.
As soon as the inal line starts to lash, there
is an autonomy of about 1.5 litres of fuel.
Speedometer
Push and hold the menu switch "SELECT"
for 3 seconds to enter the setting mode
"TOTAL KM".
Speedometers Indicates the vehicle's spe-
ed in km/h or mph. To pass from one to
the other, press the "RESET" button.
Total/partial kilometre counter
The total kilometre counter shows the to-
tal distance covered in kilometres.
Set in the mode instrumentation "TRIP A /
TRIP B" with the "SELECT" button.
The partial kilometre counter (TRIP A/TRIP
B) shows the distance covered since the
last reset in kilometres.
The partial kilometre counter can be used
to estimate the possible distance to cover
with a full tank of fuel. This information
may make it possible to schedule future
fuelling stops.
RESET/SELECT buttons
Buttons to set vehicle data.
Press the "SELECT" button to see the par-
tial or total kilometres.
When viewing partial kilometres (TRIP A/
TRIP B), it is possible to reset them by
holding down the "RESET" button for 3
seconds.
3 - 4