Use Of 12V Outlet; Changing Fuse; Changing Clock Batteries; Trouble Shooting - Bosch PB360D Instrucciones De Funcionamiento Y Seguridad

Use of 12V Outlet

Note: Do not insert any device that pulls more than 1 Amp
or else the fuse will open. 12V outlet will not operate
from battery pack.
1. Lift the rubber lid marked with 12V of the jack and insert
the plug of the device or the appliance.
2. Close the lid as soon as you finish using the outlet to
prevent any other things from entering the jack.
3. If no power is available then check fuse.

Changing fuse

1. Unscrew fuse cap in counterclockwise direction.
2. Replace fuse. Replace only with a metric 5x20mm fast
acting 1 Amp fuse (F1AL 250V).
12V
AUX 1
IN
Problem
Audio Unit doesn't
function.
It is noisy or weak
in radio receiving.
12V DC outlet
doesn't function
4-Way Power outlet
does not function
Does unit suddenly
fail to work
LINE
OUT
Trouble Shooting Guide
Checkpoint
1. Is power cord properly connected ?
2. Is the Bosch battery pack installed or
inserted properly?
3. Does the battery need charging?
1. Is there any facility interfering with
the unit.
2. Is there any interference to the
internal FM antenna?
1. Is 1 amp fuse properly inserted?
2. Has the 1 amp fuse blown open?
1. Is power cord properly connected?
2. Is red light illuminated on outlets?
1. Is power cord properly connected
to unit?
2. Is the LCD displaying that there is
power to the unit?
3. Tighten fuse cap assembly in clockwise direction.
Do not bypass the fuse or use any other
WARNING
fuse except what is specified, as it may
cause damage to the unit.

Changing Clock Batteries

1. Open battery bay door.
2. Remove AA battery cover.
3. Remove old batteries and dispose of properly.
4. Insert new AA batteries. Do not use mismatched
batteries, use only new Alkaline batteries.
Remedy
1. Plug in AC power cord.
2. Make sure battery is completely inserted.
3. Plug in power cord and insert battery.
1. Move unit to new location away from
interference.
2. Turn the unit in different directions.
1. Insert 1 amp fuse.
2. Replace fuse.
1. Plug in AC power cord.
2. Press reset button.
3. Perform GFCI testing procedure.
1. Plug in power to unit.
2. Software in unit needs to be reset. Remove all
batteries from unit and unplug AC power cord, wait for
30 seconds and reconnect AC power cord.
13
LOCATION OF AA
BATTERIES
REPLACE AA BATTERY
WHEN UNIT NO LONGER
KEEPS CORRECT TIME