Operation - Kokido DRAKBOT RC20CBX/EU Manual Del Propietário

Because the propelling nozzle can be turned 360°, after
implementing aforementioned settings, make sure the
smallest flap of 3 on propelling nozzle opening is positioned
at the bottom. Here is an example of the nozzle set at 0°
degree marking.
In case, it is difficult to clean the
debris from certain spots or
corners, turn propelling nozzle
180° from the original degree
setting (smallest flap is therefore
positioned on top) to divert water
jetting towards the pool floor in
order to move the debris or fine
particles to an area where the
cleaner has access.

OPERATION

WARNING!
- To prevent your cleaner cable from getting pulled and twisted, it is recommended to
turn off your pool's filtration system while your cleaner is in operation.
- NEVER operate the cleaner when people are in the pool.
- Check the power cord and cable for cuts before starting the operation. NEVER operate
the cleaner or Power Supply & Control unit if the power cord or floating cable is worn
or damaged. Locate the cord or cable so as to prevent it from being damaged by the
lawn movers, hedge trimmers and other equipment.
- In order to avoid overheating and potential damage of components, never cover the
power supply and control unit.
- NEVER permit children to operate this cleaner.
- Do not use the cleaner if the pool temperature does not fall into this range:
10°C – 40°C (50°F – 104°F)
- If there are stones, roots or metal corrosion in contact with the underside of the liner,
clean them out before operating the cleaner. If necessary, have a qualified professional
do the cleaning.
- If the liner is brittle or damaged, have a qualified professional perform the necessary
repairs or liner replacement before operating the cleaner.
- Remove articles from the pool deck/top frame before operating the cleaner.
- Remove the pool ladder from the pool before operating the cleaner.
CAUTION:
- In order to avoid causing severe damage to the cleaner, do not switch on the cleaner
until it is fully submerged in water.
- Remove hazardous obstacles such as children's toys, floating loungers and chemical
dispensers, etc. from the pool before placing the cleaner in water and initiating
operation.
- The cleaner must be installed and operated as specified in this manual.
12