Idiomas disponibles
Idiomas disponibles
Caution:
Please note that your Proxxon power tool may
only be operated with the appropriate Proxxon
battery and that the charger is to be used exclu-
sively for the charging of these batteries.
Furthermore, no other charger may be used
to charge the Proxxon battery: The respective
Proxxon components are optimally coordinated.
Please note: The device, battery and charge are
also separately available at retailers!
When delivered, the battery is partially charged
and must be charged completely before com-
missioning the device. To do so, proceed as
follows:
1. Insert the plug of the charger.
2. Insert battery 1 in the charger 2 as shown in
Fig. 2.
3. The yellow light-emitting diode 3 signals the
charging process. When completed, the green
light-emitting diode 4 lights up.
4. Remove the completely charged battery from
the charger.
5. Insert battery 1 as shown in Fig. 3 in the
housing opening of the device until it engages.
To protect the battery from harmful total dischar-
ge while in operation, the charge status is per-
manently monitored electronically and the de-
vice will switch off before it reaches the critical
discharge condition. The battery will now need
to be recharged. Do not attempt to put the device
back into operation with a discharged battery!
6. To charge, press the release buttons 2, pull out
the battery to the rear and carry out steps 1-5.
The charging process can be interrupted at any
time and continued without damage to the battery.
Caution:
Drastically reduced operating times after the
charging process indicates that the battery
needs to be replaced!
If after inserting the battery into its designated
- 18 -
All manuals and user guides at all-guides.com
opening the light-emitting diode fl ashes instead
of glowing yellow continuously, the cause may
be a too high temperature, a defect, or the total
discharge of the battery.
• If the battery is too hot, the charging process
will start automatically after it cools down.
• If, on the other hand, the battery has a
normal temperature but is totally discharged,
the charger will check if it still draws power or
it if is already defective.
• If the battery can be recovered, the yellow
light-emitting diode will glow continuously after
some time, signalling the successful charging
process.
• If the yellow light-emitting diode fl ashes, the
battery is defective and needs to be disposed
of; see also "Note on disposal within the EU"
later on in these instructions.
General handling of the device:
Caution:
• Wear a protective mask if large amounts of
dust or harmful dusts accumulate.
• Insert the tools as short as possible when
clamping. Ensure that the shaft of the tool does
not stand out more than 30 mm from the collet.
Excessively protruding shafts can bend easily
and contribute to poor concentricity.
• A correct and consistent speed achieves a high
grinding performance, not excessive contact
pressure!
• By tendency: Bits and cutters with smaller
diameters require higher speeds than those
with a larger diameter.
• Caution: You absolutely must observe the
permissible maximum speed of the bits and
cutters! The tool can break when the maximum
permissible speed is exceeded. Flying parts
can cause damage and severe injuries!
• Never press the lock button while the device
is operating.
• A collet chuck is inserted in the spindle of the
device ex works!
• Depending on the collet size, bits and cutters
may have a shaft diameter of max. 3.2 mm.
• Insert the tools are far as possible when clam-
