Idiomas disponibles
Idiomas disponibles
MOUNTING THE GUARD
NOTICE: Install the guard before the
attachment is connected to the power head.
WARNING:
injury to people, do not operate without
guard in place.
WARNING:
when mounting or replacing the guard. Be
careful of the line-cutting blade on the guard
and protect your hands from being injured
by the blade.
1. Loosen the two bolts in the guard
with the supplied hex key; remove
the bolts and spring washers from
the guard (Fig. 2).
2. Lift the trimmer head and face it
upward; align the two mounting
holes in the guard with the two
assembly holes in the base of the shaft. Make sure that the internal surface of the
guard faces towards the trimmer head (Fig. 3).
3. Use the supplied hex key to secure the guard in place with the bolts and washers.
CONNECTING THE STRING TRIMMER ATTACHMENT TO THE POWER HEAD
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This string trimmer attachment is designed for use with EGO Power Head PH1400/PH1400-FC/
PH1420/PH1420-FC.
The string trimmer attachment connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob on the power-head coupler.
18
STRING TRIMMER ATTACHMENT — STA1600/STA1600-FC
To reduce the risk of
Always wear gloves
Never attach or adjust any attachment while the power head is
2
Line-cutting Blade
3
