Fulgor Milano F7PBW24S1-R Manual De Usuario página 21

11. TROUBLESHOOTING GUIDE
EN
11.1 Troubleshooting guide
If you notice malfunctions in your appliance, use
this guide before calling Service. This guide may
help you resolve the problem yourself or could
provide important information to ensure rapid
and effective service.
Malfunction message
A malfunction is usually indicated on the display.
Problems that cannot be resolved by the user
are signalled through a malfunction code.
The appliance does not work
Is the appliance connected to the electrical pow-
er supply?
Does electrical power arrive at the electrical
socket?
Is the Unit power activated?
Is the condenser clean?
The internal temperatures are higher than
normal
Does the display show a malfunction code?
Is the temperature adjusted correctly?
Is the condenser clean?
Were the doors or drawers open for a long period
of time?
Were large quantities of food recently inserted?
The compressor runs for a long time period
Bear in mind that during a very hot weather and
with very high temperatures in the room it is nor-
mal that the compressor remains in operation for
prolonged periods of time.
Were the doors or drawers open for a long period
of time?
Were large quantities of food recently inserted?
Is the condenser clean?
Check that the doors are closed and that the food
or containers do not obstruct the perfect closure
of the door.
Is Shopping mode enables?
If you hear strange noises
It is normal to hear noise from the fans or com-
pressors during the defrost phase.
Noise could be louder depending on the position
of the appliance and the surrounding environ-
ment.
40
Condensation forms both inside and out
If the climate is very humid, the formation of con-
densation is normal. Opening the door or draw-
ers for prolonged periods of time can contribute
to the formation of condensation.
In any case, make sure that the doors are always
perfectly closed and the gasket is making a good
seal.
The Cooler or Freezer has frost or ice
Did you leave the doors open for a long period of
time?
Do the doors close perfectly?
If the doors do not close perfectly, contact your
installer.
Unpleasant odours inside the appliance
Clean the appliance completely as indicated in
this manual.
Hermetically cover all the food. Do not conserve
food for prolonged periods of time.
The doors are difficult to open
The appliance was designed to permit hermetic
closure.
When the door is closed, a vacuum situation can
occur: in this case it is necessary to wait a few
seconds until the pressure balances before open-
ing the door.
11.2 Malfunction indications appearing on the display
Display message Malfunction description
Prolonged interruption of electrical power
Power Failure The appliance starts up again automatically and indicates
the highest recorded temperatures.
Door open
Door open
this message appears few minutes from the door opening
Drawer open
Drawer open
this message appears few minutes from the drawer opening
Cellar (Wine Cellar) compartment too warm
Cellar too warm
See the troubleshooting guide
Cellar (Wine Cellar) compartment too cold
Cellar too cold
Wait 12 hours. If the problem persists, contact Customer Care
Cantina compartment too warm
Cantina too warm
See the troubleshooting guide
Cantina compartment too warm
Cantina too cold
Wait 12 hours. If the problem persists, contact Customer Care
FreshZone compartment (cooler mode) too warm
Cooler too warm
See the troubleshooting guide
FreshZone compartment (cooler mode) too cold
Cooler too cold
Wait 12 hours. If the problem persists, contact Customer Care
FreshZone compartment (freezer mode) too warm
Freezer too warm
See the troubleshooting guide
FreshZone compartment (freezer mode) too cold
Freezer too cold
Wait 12 hours. If the problem persists, contact Customer Care
Functional problems
Error Code... call Customer Care who may help you to salve the problem or put you in
contact with the nearest Service Agent
Check Condenser
Check condenser Every 12 months the display shows the message "Check Cond", clean the
condenser and follow the instructions for resetting or disabling the timer.
> In case of anomalities, touch the button Alarm
with its error number code.
> The message will be shown for 3 seconds, then it will go back to the home
>
For holding the message on the screen, press on the display, the button info
screen for 30 seconds, then it will go back to the home screen.
> In the case there is more than one error message, the display will show in timed sequence the different
messages.
and the display will show the corresponding message
screen.
Modalità
( ). The message will be on the
Bottle Cooler
On O
EN
41