Idiomas disponibles
Idiomas disponibles
B
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Without any operation in five seconds or press the Power button to end the setting mode,
the setting is memorized by the programme.
WATER HARDNESS
°dH
Mmol/l
1)
0 - 5
0 - 0,9
6 - 11
1,0 - 2,0
12 - 17
2,1 - 3,0
18 - 22
3,1 - 4,0
23 - 34
4,1 - 6,1
35 - 45
6,2 - 8,0
German degree of measurement for the water hardness
1)
millimol, internationel unit for water hardness
2)
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
3)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
* factory setting
Using the appliance
Setting on the water
softener
2)
1
2
3
4 *
5
6
17
Digital display
stalls
H1
H2
H3
H4
H5
H6
EN
Regeneration
occurs every
X program
sequence
3)
No regeneration
10
5
3
2
1
