Safety Instructions - Deltaco EV-1125 Manual Del Usuario

ENG

Safety instructions

1. Follow the manual to use this device.
Failure to follow instructions may result in
danger to person or damage to property.
2. You must also follow the documentation
regarding charging of your electric vehicle.
3. Regularly check the charger for visible
damages. Risk of electric shock when
using a damaged charger.
4. Before powering on the device, please
confirm that the device is properly ground-
ed to avoid accidents.
5. Do not use the charger if it is damaged.
6. Do not open up or modify any part of
the device by yourself. Only authorized
electricians with safe tools may perform
maintenance.
7. Before powering on the device, confirm
that the voltage and ampere from the
power supply matches this device.
8. Use only for electric vehicle charging.
9. Do not use this device with an extension
cable or adapter.
10. Do not disconnect while the device is
charging.
11. Protect this device from liquids/water,
rain, wind, snow and sand, even if it is IP66
rated, safety first.
12. Storage at min -40°C max +70°C am-
bient temperature. The ambient air should
not contain acids, alkalis or other corrosive
or explosive gases.
13. Connect this device to an earthed
contact.
14. Do not let the charger hang by the ca-
ble, the wear damage on the cable and the
contacts can become considerable high
since the cable and charger are heavy.
Risk of electric shock, damage to property
and injury to person. You have to support
the weight of the charger and cable in safe
and stable way. For example hang the
charger on a hook, via the hang hole on
the back of the product.
15. If you have the charger or cable on the
7
ground, they can be easily be damaged,
keep them off the ground and protected
from fall damage.
16. This product may cause a tripping
hazard.
17. Old or erroneous contacts or cable
line branches in the building can cause
overheating at high loads, which in turn can
be a fire risk. Because of this risk, let an
authorized electrical installation company
check the electrical installation.
18. This information is only applicable on
EV-1125, EV-1225: Regular wall outlets
and engine preheater outlets (Schuko
type), are not made for electric vehicle
charging and can't handle recurring high
load over long periods. Therefor limit the
charge to 10A. This limitation does not
include industrial contacts (IEC/EN 60309).
Use locations
Typical use locations for this product
would be sheltered locations or areas with
roofs, such as a garage or a parking lot
with a roof.
Compatibility
Charger EV-1125 is for all electrical
vehicles with Type 1 contacts.
Charger EV-1225/EV-1227 is for all electri-
cal vehicles with Type 2 contacts.
Don't use them with other types.
Use
1. Connect to a power supply. (To an
earthed contact)
2. Use the button to switch am-
pere:EV-1125/EV-1225 is 10A/16A and
EV-1227 is 6A/8A.
3. Connect to the electrical vehicle's
contact.The charger automatically detects
the connection status and handshaking
protocol, and starts charging.
LEDs (EV-1125/EV-1225)
The LED marked with the word "Power"