Electrical Connection - Casselin CPASF30B Manual De Instrucciones

EN
Thoroughly clean all parts of the device before using it with a suitable product. The control box must not
be in contact with water or humidity.
The appliance your appliance under an extractor hood (the water vapor which escapes from the appliance
during its operation can thus be evacuated).
The device can be used in ordinary space according to EN 332000-1.
Ensure that the device is placed so that the user has enough space to operate it.

ELECTRICAL CONNECTION

ELECTRICAL HAZARD! Danger due to electric current!
The device can cause injury if not properly installed. Before proceeding with its installation, compare the data
of the local electrical network with the indications which appear on the nameplate of the appliance.
• Connect the device only if there is conformity.
• Comply with safety rules.
Before connecting the device, make sure that the nominal voltage and frequency listed on the nameplate
comply with the values of the local electrical network: the maximum voltage difference must be plus or minus
10%.
A switch with a contact opening of at least 3mm must be installed between the electrical socket and the
appliance.
The device must be earthed.
Place the device so that the socket is easily accessible in order to unplug the device if necessary.
MANUAL
Before using the device for the first time, it must be cleaned using a damp cloth and a suitable detergent.
Rinse and dry.
Switch on the device using the main "ON/OFF" switch. The green power-on indicator light comes on.
Turn the thermostat knob to the desired temperature. The second orange indicator light is on when the
resistances heat up and goes off when the desired temperature is reached. To turn off the appliance, position
the thermostat button on "0" and press the main switch.
After use, allow the device to cool down.
Check and empty the grease container regularly.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.