Black and Decker GH900 Manual De Instrucciones página 13

Switching Trimmer On and Off (Fig. A)

WARNING:
trigger in the on position.
1. To turn the appliance on, squeeze the trigger
2. To turn the appliance off, release the trigger.
Trimming (Fig. K, L)
1. With the trimmer on, angle it and swing side to side as
shown in Fig. K.
2. Maintain a cutting angle of 5 ° to 10 °. Do not exceed 10 °.
3. Cut with the tip of the line.
4. Maintain a minimum distance of 24" (610 mm) between
the guard and your feet as shown in Fig. L.
Convert to Edging Mode (Fig. A, K, L)

WARNING:
power source before making any adjustments.
The trimmer can be used in trimming mode or edging mode
to trim overhanging grass along lawn edges and flower beds.
1. To operate in edge mode, loosen the collar
it counterclockwise.
2. Rotate the motor housing
until the motor housing snaps into edge position.
3. Twist the collar 7 clockwise until tight to secure it
into position.
4. To return to the trimming position, loosen the lock collar
and rotate the motor housing
its original position and tighten the collar
into position.
nOTE: You will experience faster than normal cutting line
wear if the trimmer line is positioned directly over the
sidewalk or abrasive surface.
Edging Mode Operation (Fig. A, L)

WARNING:
stones, pieces of metal and other objects can be thrown
out at high speed by the line. The trimmer and guard
are designed to reduce the danger.
However, MAKE SURE that other persons and pets are at least
100' (30 m) away. Optimum cutting results are achieved on
edges deeper than 2" (50 mm).
• Do not use this trimmer to create trenches.
•
Using the edge guide
• Position the edging guide on the edge of the sidewalk
or abrasive surface so the cutting line is over the grass or
dirt area to be edged.
• To make a closer cut, slightly tilt the trimmer.
Helpful Cutting Tips (Fig. A, I, J)
• Use the tip of the string to do the cutting; do not force
string head into uncut grass. Use edge guide along such
things as fences, houses and flower beds for best practices.
Never attempt to lock the
1
Disconnect the plug from the
7 by twisting
9 180 ° counterclockwise,
9 180 ° clockwise back to
5 to secure it
When being used as an edger,
10
, guide the trimmer.
• Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear string rapidly.
• Do not allow spool cap
other surfaces.
• In long growth, cut from the top down and do not
.
exceed 13" (330 mm) high.
• Keep trimmer tilted toward the area being cut; this is the
best cutting area.
• The trimmer cuts when passing the unit from the left to
right. This will avoid throwing debris at the operator.
• Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the string.
Cutting Line / Line Feeding
Your trimmer uses .065" (1.65 mm) diameter, round nylon
line. During use, the tips of the nylon lines will become frayed
and worn. Cutting line will wear faster and require more
feeding if the cutting or edging is done along sidewalks or
other abrasive surfaces or heavier weeds are being cut.
Clearing Jams and Tangled Line (Fig. N)

WARNING:
the power source before making any assembly,
adjustments or changing accessories. Such preventive
safety measures reduce the risk of starting the
appliance accidentally.
From time to time, especially when cutting thick or stalky
weeds, the line feeding hub may become clogged with
sap or other material and the line will become jammed as a
result. To clear the jam, follow the steps listed below.

CAUTION:
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
1. Disconnect the plug from the power source
2. Press the release tabs
remove the spool cap from the spool housing
3. Pull the nylon line spool out and clear any broken line or
cutting debris from the spool area.
4. Fit the spool onto the appliance as described in
Replacing Spool Assembly.
Replacing Spool Assembly (Fig. M—P)

WARNING:
recommended by BLACK+DECKER for use with this
appliance could be hazardous.

WARNING:
or any accessory or attachment other than those
recommended by BLACK+DECKER on this trimmer/
edger. Serious injury or product damage may result.
Reload nylon line (either bulk or prewound replacement
spool) as shown in this manual.
19 to drag on ground or
Disconnect the plug from
To avoid appliance damage, if
20 on the spool cap 19
12
The use of any accessory not
Do not use any blades,
English
, and
.
11