Operating The System - Volvo Penta QL Instrucciones De Usuario

This is the confirmation that the calibration is correctly
done. If the calibration was not successful, an error code
will pop up. If starboard interceptor was not successfully
calibrated, the right LEDs, No 6 and 7 will flash. If port
interceptor was not successfully calibrated, the left LEDs,
No 6 and 7 will flash (see also under the headline Error
codes). If this will happen, shut off the power to the
system, and investigate why the blades do not move
(mechanical obstacle, clogged up by paint or acorn
barnacles). Remove the obstacle and recalibrate.
If a control unit for two pairs of interceptor units is used,
but only one pair of interceptors is installed, thus the
control unit is calibrated with only one pair of intercep-
tors, it is necessary to re-calibrate the system if another
pair of interceptors is installed later on.
If the control unit or any of the interceptor units, for any
reason later on are replaced, the system has to be reca-
librated.
Now the system is ready for operation. Note! In connec-
tion to the boat launch, always check the interceptor in-
stallation regarding water leakage through the transom!
If any leakage, the installation is not properly done and
must be redone.

Operating the system

The control panel has four buttons. The upper button lo-
wers the blades in paralell (bow down). The lower button
retracts the blades in parallell (bow up). The left button
lowers the starboard blade and retracts the port blade
(tilt port). The right button lowers the port blade and
retracts the starboard blade (tilt starboard). The blade
operation starts when pressing the button and stops
when releasing it. The LED:s on the panel have variable
light intensity in four steps and OFF. By pressing the left
and right buttons simultaneously for approx 1 second,
the light intensity of the LED:s takes one step down. As
long as the 2 buttons are pressed in, the intensity takes
one more step down for each 0.5 second. When the in-
tensity reaches the OFF level, it returns to maximum in-
tensity again and keeps toggling like this as long as the
2 buttons are pressed in. When the buttons are released,
the intensity of the LED:s will stay at the current value. If
several panels are connected to the system, only the
panel where the buttons are pressed will be affected.
After power off, the panel LED:s will restart at maximum
light intensity when power on.
When the engine stops (power supply to the panel is
lost), the blades will fully retract.
Note! If more than one helm station is installed, the engi-
ne must be stopped from the main station (the station
where the red cable from the control panel is connected
to 12V or 24V).
14
Plus d'informations sur : www.dbmoteurs.fr