ANSMANN BABYPHONE BERLIN Instrucciones De Manejo página 7

trOuBle shOOting
MalfunctiOn sOlutiOn
no function
• check the current supply
• is the mains adapter attached correctly?
• Have the accumulators or batteries been correctly inserted?
• are the accumulators charged?
no transmission
• reduce the distance of the transmitter to the baby, while observing the minimum distance of 1m or
increase the sensitivity
• reduce the distance of the receiver to the transmitter. check the position of the channel selector
switches (2). Both must be in the same position
• the transmitter must be next to the baby
• are both devices switched on?
disturbed transmission
• select another transmission/reception channel
• reduce the distance of the receiver to the transmitter. check the accumulators/batteries and replace
them, if necessary
• reduce the distance of the receiver to the transmitter.
no warning tone
• push alarm switch (7) in the battery compartment to On
whistling (feedback)
• increase the distance of the receiver to the transmitter
• reduce the volume on the receiver
random noise
• check the batteries and replace them, if necessary.
• check the position of the channel selector switches (2). Both must be in the same position.
Battery control display
• the rechargeable batteries or batteries in the receiver of the receiver are empty flashes "red"
• new batteries must be inserted
• used accumulators must be recharged with a separate battery charger
• the device must be connected to the accompanying mains adapter, if an battery pack is used. the
charging procedure is then displayed by the change of the led colour, which goes from red flashing to
permanent green