Mode
JET mode
• This mode is for removing food
particles trapped between the teeth.
AIR IN (REGULAR) mode
• This mode is for periodontal pocket
cleaning and gum care.
AIR IN (SOFT) mode
• This mode is for gently massaging
the gums.
Notes
• When you use the appliance for the first time,
press the power switch to turn the appliance on
and test each of the water jet modes with the
tank filled with water.
• The appliance may not operate in an ambient
temperature approximately 5 °C (41 °F) or lower.
• Do not hold the tip of the nozzle firmly against
the teeth or gums. (Except orthodontic nozzle)
• Since plaque adhering to the surface of teeth
cannot be removed only with water flow,
brushing is always necessary. It is
recommended to clean inside your mouth with
water flow after brushing your teeth.
• Do not operate the main unit when empty other
than when pouring out any remaining water
after use. Operating the main unit without water
may result in a malfunction.
EW1213_US.indb
11
Description
5
5
Place the nozzle in your
mouth and close your
mouth gently before
pressing the power switch�
• To use, place your face over a
sink, and with the main unit
upright and the nozzle at the
top, raise your elbow.
• Pressing the mode switch during use will change
the mode.
• A fully filled water tank provides approximately
35 seconds of use. (When using the nozzle (for
general use))
• If the nozzle is inclined too much, water will come
out of the ventilation hole instead of the nozzle.
(The ventilation hole in the rear of the main unit
allows for easier water suction of the hose.)
Turn the nozzle handle to adjust
the direction of the water flow.
6
6
After use, press the power switch to turn
off the main unit�
• Stop operation with the nozzle still in the mouth to
prevent water from splashing.
11
2020/06/22
16:53:08