EGAmaster 51660 Manual De Instrucciones página 11

- Use only genuine replacement parts. Service and maintain the unit only with authorized or
approved replacement parts negligence will make the jack unsafe for use and void the warranty.
- Carefully inspect the unit on a regular basis and perform all maintenance as required.
- Store these instructions in the handle of your jack. Keep all decals on the unit clean and
visible.
- Safety: always follow safety precautions when installing and operating this jack.
- Before proceeding ensure that you fully understand and comprehend the full contents of this
manual.
- Failure to operate this equipment as directed may cause injury or death.
- The distributor is not responsible for any damages or injury caused by improper use or neglect.
Always use Jack Stands!
DO NOT USE wood blocks or any other non-approved load sustaining devices. The
manufacturer only warrants loads to be sustained by jack stands that meet current ASME
standards.
DO NOT USE wood blocks or any other non-approved lifting devices for a means of lifting with
the jack and or load being raised. Failure to head these warnings may cause injury or death.
ASSEMBLY INSTRUCTIONS
For easiest transportation the jack is not assembled at the time of purchase .Please refer to the
exploded drawing and the instructions below to assemble your new transmission jack stand.
Step 1- The Base
(a) Attach the four ball bearing caster wheels to the 4 respective legs of the jack stand making
sure to tighten the screws.
(b) Connect the legs with the bolts and screws provided.
Step 2 - The Cylinder
(a) Loosen the bolts on the base.Put the cylinder on the right position on the base of the stand
and tighten the bolts.
Step 3 - The Saddle
(a) Slide saddle into the ram.
TO USE
(a) To raise the ram simply pump the pedal.
(b) To release turn and hold the release valve counter clock wise.
11