Mixed Dust Containing Metal And Sanding Damp Surfaces; Emission Levels; Intended Use; Technical Data - Festool ETS EC 125/3 EQ Manual De Instrucciones

– If potentially explosive or self-igniting dust
is produced during sanding, the machining
instructions issued by the material manu­
facturer must always be followed.
Clean using materials soaked in oils, e.g.
–
abrasive pad or polishing felt with water,
and spread them out to dry. Materials
soaked in oil may ignite spontaneously.
Always use original Festool backing pads.
–
Pads from other manufacturers can break.
– Damaged or worn sanding tools may not be
used.
– If the power tool is dropped or falls, check
for damage to the machine and sanding
pad. Remove the sanding pad for closer
inspection. Have the damaged parts re­
paired before use. Broken sanding pads
and damaged machines can cause injuries
and machine instability.
Only for AS/NZS: The tool shall always be
–
supplied via residual current device with a
rated residual current of 30 mA or less.
2.3 Mixed dust containing metal and
sanding damp surfaces
With mixed dust containing metal (such as
dust resulting from paint sanding in the auto­
motive field) and when sanding damp surfaces,
the following measures must be observed for
reasons of safety:
– Install a residual-current circuit breaker
(GFCI, PRCD) upstream.
– Connect the machine to a suitable dust ex­
tractor.
– Regularly blow out the motor housing of
the machine to remove dust deposits.
Wear protective goggles.
2.4

Emission levels

The levels determined in accordance with are
typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
three directions) and uncertainty K measured in
accordance with :
Vibration emission level (three-
axle)
The specified emission levels (vibration, noise)
–
–
–
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
► Depending on the actual load, suitable pro­
3
The sanders are designed for sanding wood,
plastic, composite, paint/varnish, filler and sim­
ilar materials as directed. With mixed dust con­
taining metal (such as dust resulting from paint
sanding in the automotive industry) and when
sanding damp surfaces, special safety instruc­
tions must be followed. The sanders are not in­
tended to be suitable for grinding bare metal.
Material containing asbestos cannot be pro­
cessed.
4
Eccentric sanders
L = 69 dB(A)
PA
Power
L = 80 dB(A)
WA
Speed (no-load)
K = 3 dB
Sanding stroke
Sanding pad
Weight
are used to compare machines.
They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
They represent the primary applications of
the power tool.
CAUTION
cycle must be evaluated.
tective measures must be defined in order
to protect the operator.

Intended use

The user is liable for improper or non-in­
tended use.

Technical data

English
(vector sum for
h
a = 4.8 m/s 2
h
K=1.5 m/s
2
ETS EC 125/3 EQ
400 W
6000 - 10000 min -1
3.0 mm
D 125 mm
1.2 kg
13