Honeywell CO30XE Manual De Instrucciones página 17

USE & OPERATION (CONTINUED)
CLEANING THE HONEYCOMB COOLING MEDIA
• The appliance is supplied with a Honeycomb Cooling Media.
• The Honeycomb Cooling Media is located inside the Rear Grill. (See Figure 1) and see below for
instructions on how to remove them from the unit for cleaning.
• Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
•
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh
water at least once a week will help reduce mineral deposits. If mineral deposits remain on the
Honeycomb Cooling Media, the media should be removed and washed under fresh water. The
media should be cleaned every two months or sooner, depending on your needs.
•
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
Removing the Honeycomb Cooling Media:
1. Remove all the screws from the Rear Grill of the
Air Cooler.
2. Carefully pull out the rear grill from the cooler.
3. The Honeycomb Cooling Media is secured on
the Honeycomb Frame by a Horizontal Bar that
is fixed in place by two screws. Remove these two
screws to release the Horizontal Bar and slide the
Honeycomb out of the frame.
4. Replace or clean media with water and a damp
cloth as needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill or Honeycomb Frame is removed from
the Air Cooler, or if there is a loose-fitting Rear Grill
or Honeycomb Frame. Doing so can cause serious
injury or dangerous electrical shock.
Figure 1:
EN 8
Honeycomb
Cooling Media
Horizontal Honeycomb
Bar Frame
Screw
Rear Grill