Casals CSC36VA Manual De Instrucciones página 6

the screwdriver handle. - Connect the USB input to
a USB port.
- The red pilot light (Fig 2) will illuminate to indicate
that the charger is charging the battery.
- Approximately 3 to 5 hours are needed for a com-
plete charge of the battery. Never attempt to over
charge the battery (although it is recommended
that the first charge of the battery be of 5 hours in
duration).
Charging indication:
The LED battery level indicator (Fig 2a) should be
able to tell you the amount of charge that you have
on the battery. For the indication press the button
(Fig 2b)).
CHARGING
Red light
•ON
Charger is con-
nected to the
mains
The battery is
charging
Battery fully
charged
NB: Do not use the appliance while it is connected
to the charger.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
Screwing, unscrewing: (Fig 6)
- Insert the screwdriving bit or tool/accessory bit
required for the job. To do so, fit the hexagonal
male end into the hexagonal female socket on the
bit holder (1) and press until it holds firmly.
See below diagram:
Rotation direction
Charger is connected to
the mains
The battery is charging
Inserting / clamping screwdriver bits
- As soon as the motor stops, the drive shaft auto-
matically locks.
CSC36VA_IM.indd 6 CSC36VA_IM.indd 6
Green light
ᴥ
ᴥ
ᴥ
Switch position (view
from the top)
- Insert the desired bit into the chuck's hexagon
socket (fig. 3).
Switch lock
- The ON/OFF switch can be locked in the OFF
position. This feature can be used to prevent the
possibility of accidental starting when not in use.
To lock ON/OFF switch, place the direction of Fig
6 (rotation selector (Forward/Reverse Selector) in
centre position.
- Note: When selector is in centre position, ON/
OFF switch is locked.
Screwing
- Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
- Place the point of the driver bit in the screw head
and apply pressure to the tool. Start the tool slowly
and then increase the speed gradually. Release
the ON/OFF switch as soon as the clutch cuts in.
- Make sure that the driver bit is inserted straight
in the screw head, or the screw and/or bit may be
damaged.
Screwing into wood
- When screwing the screw on the edge of the
wooden material you should predrill a pilot hole,
which will reduce the likelihood of splitting. Use
a drill with a diameter about 70% of the screw
diameter.
- We recommend using self-centering screws
designed for reliable working.
- Be sure to use a bit that matches the screw in
shape and size.
- If screws are difficult to tighten, try applying
a small amount of washing liquid or soap as a
lubricant.
LED light
- When depressing the ON/OFF switch the LED
light (8) serving for lighting the workplace in front of
the tool clamped in the chuck, will go on automati-
cally.
Adjusting the handle
- To change the positions, depress handle release
button (Fig 4A) and swivel handle to desired posi-
tion (Fig 4B).
Setting the rotation speed
- By pressing the ON/OFF switch (fig. 5) you can
set the rotation speed during idle operation.
- The optimal rotation speed depends on the work
piece, the operation mode, and the inserted ac-
cessory. Select the speed by applying a greater or
lesser pressure to the ON/OFF switch.
2021/04/20 09:50 2021/04/20 09:50