•
Never attempt to open the tool for any reason. If the tool case is cracked or damaged,
do not charge. Do not crush, drop or damage the tool. Do not use a tool or charger that has
received a sharp blow, been dropped, run over or damaged in any way (e.g., pierced with a nail, hit
with a hammer, stepped on). Damaged tools should be returned to the service center for recycling.
Storage Recommendations
The best storage place is one that is cool and dry, away from direct sunlight and excess heat
or cold. Store the fully charged tool disconnected from the charger.
Transportation
nOTE: Integral Li‑ion tools should not be put in checked baggage on airplanes and must be
properly protected from short circuits if they are in carry‑on baggage.
Tool Disposal
This product uses a lithium‑ion rechargeable and recyclable battery. When the battery no longer holds a
charge, the tool should be recycled. The tool should not be incinerated or placed in the trash.
The tool can be taken for disposal to an Authorized Service Center. Some local retailers are
also participating in a national recycling program (refer to RBRC®). Call your local retailer
for details. If you bring the tool to an Authorized Service Center, the Center will arrange
to recycle the tool and its battery. Or, contact your local municipality for proper disposal
instructions in your city/town.
Important Safety Instructions for All Integral Battery Charging
WARNING: Read all safety warnings, instructions, and cautionary markings
for the battery, USB cable and product. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury.
•
The provided USB cable is not intended for any uses other than charging
BLACK+DECKER rechargeable tools with micro USB ports. Charging other types of
tools may cause their batteries to overheat and burst, resulting in personal injury,
property damage, fire, electric shock or electrocution.
•
Use only with the Listed/Certified Information Technology (computer) Equipment.
•
DO NOT expose USB cable to water, rain or snow.
•
Pull by the plugs rather than the cord when disconnecting the USB cable. This will
reduce the risk of damage to the plugs and cord.
•
Make sure that the cord is located so that it will not be stepped on, tripped over or
otherwise subjected to damage or stress.
•
When charging the tool outdoors, always provide a dry location.
English
9