Tabla de contenido
ENGLISH
CARE FOR YOUR SHAVER
Care for your product to ensure a long lasting performance. We recommend that you clean
it after each use.
•
When cleaning your shaver, make sure it is turned off and disconnected from the
charging cable.
SAFETY MODE
•
Your head shaver will turn itself off and enter safety mode if the demand on the battery
is too high. This can be because of inadequate cleaning or excessive hair clippings in
the hair pocket.
•
If this occurs, open and clean your shaver. The left and right charging indicator lights
will flash for ten seconds. After an additional 5 seconds your shaver will reset itself and
be ready to operate as normal.
AFTER EACH USE
1.
Pull the cutting head unit off the head assembly (fig. A).
2.
Empty out any hair clippings. The head can be rinsed under a running tap (fig. B).
3.
Use a cleaning brush to remove any shaving debris.
•
The shaver is washable and can be cleaned by rinsing under warm water.
•
When using shaving creams or gels with the shaver it is especially important to clean
after each use to prevent the gel from drying and clogging the cutters.
•
When cleaning the external surfaces of the shaver, do not use strong detergents or
other chemicals.
•
To dry, wipe the surface of the shaver with a dry cloth or towel.
•
The shaver head assembly is designed to be detachable from the shaver body. Simply
pull it away from the body of the shaver. To reattach, align it with the opening on the
body and click it into position.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
Ensure the device is discharged of all power. To do this, switch it on and allow it to run
until it stops.
2.
Remove the head assembly by pulling it off.
3.
Using a small screwdriver, pry the front panel off the handle.
4.
Pry off then remove the two side panels.
5.
Using a small flat screwdriver, pry off the display panel.
6.
Unscrew the 4 screws and open the front housing.
6
Tabla de contenido
