Tabla de contenido
Idiomas disponibles
Idiomas disponibles
△When transporting the chest freezer from one place to another, the
Transportation and Placement
inclination of the cabinet should not exceed 45 degrees, for prevention against
△Before use, remove all the packing material. The back side of the cabinet
compressor or system damage.
should be more than 20cm away from the wall, both flank sides more than
△The freezer should be put in well-ventilated, dry place. Don't use it under
20cm.
direct sunshine. The freezer should be kept away from water sink, heat source
and any volatile, corrosive material.
△Specified capacity of the wire is 6A. Section squares of the wire is 0.75mm.
Power source and test-running
Single line or compound lines are all allowed. The fuse of 2.5A specified
electric current should be installed.(Power cord should be replaced with the
△Single-phase power supply, 50Hz, voltage range 187~242V. If the voltage is
same of 6A and 0.75mm, when it is damaged).
△Avoid turning on and off the power too frequently. If the power is turned off,
unstable, please install a voltage stabilizer with capacity above 1000W.
△When the freezer will be out of use for a long time, disconnect the power first,
wait an interval of 5 minutes before turning it on again.
then clean it. Please examine the circuit whether it is excellent before reuse.
△The temperature in the cabinet can be controlled with the temperature
Operation of the Temperature control knob
△The knob should be kept upright normally to adjust the temperature.
control knob.
FREEZING MAX is the strongest cooling position and is suitable for fast
△1 stage-14 ~-16 °c 2 stage-16~-18 °C 3 stage-18 ~-20 °c 4 stage-20 ~-22 °c
freezing. Do not keep the knob at this point for long.
5 stage-22 ~-24 °c 6 stage-24 ~-27 °c 7 stage no stopping
△There must be space between the foods stored in the cabinet, between the
Food storage
6
Tabla de contenido
