Características De Entrada/Salida - Yamaha DME8i-ES Manual De Instrucciones

Referencias
LED Level Meter
<DME8i-ES>
METERING POINT
<DME8o-ES>
METERING POINT
<DME4io-ES>
METERING POINT
Signal Delay
from
Analog input of Primary Master
Características de entrada/salida
ANALOG INPUT CHARACTERISTICS
Input Terminals
<DME8i-ES>
CH INPUT 1–8
<DME4io-ES>
CH INPUT 1–4
ANALOG OUTPUT CHARACTERISTICS
Output Terminals
<DME8o-ES>
CH OUTPUT 1–8
<DME4io-ES>
CH OUTPUT 1–4
DIGITAL INPUT & OUTPUT CHARACTERISTICS
Terminal
EtherSound
42
DME8i-ES/DME8o-ES/DME4io-ES Manual de instrucciones
INPUT 1–8
OUTPUT 1–8
INPUT 1–4
OUTPUT 1–4
to
Analog output of the slave
GAIN Actual Load
Impedance
–60dB
3kΩ
+10dB
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All AD converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
*3.+48V DC (Phantom power) is supplied to CH INPUT EUROBLOCK connectors via each individual software
controlled switch.
Actual Source
Impedance
75Ω
*1.In these specifications, 0dBu is referenced to 0.775 Vrms.
*2.All DA converters are 24-bit linear, 128-times oversampling (Fs=48kHz)/64-times oversampling (Fs=96kHz).
Format Data length
EtherSound 24bit
CONDITIONS
PEAK red LED: ON
SIGNAL green LED: ON
CONDITIONS
PEAK red LED: ON
SIGNAL green LED: ON
CONDITIONS
PEAK red LED:ON
SIGNAL green LED:ON
CONDITIONS
via EtherSound @ 48kHz
For Use With
Nominal
Nominal
–60dBu
(0.775mV)
50–600Ω Mics &
600Ω Lines
+10dBu
For Use With
Nominal
Nominal
600Ω Lines +4dBu (1.23 V)
Level
100Base-TX
MIN TYP
–3
–40
MIN TYP
–3
–40
MIN TYP
–3
–40
MIN TYP
Input Level
Max.before clip
–40dBu
(7.75mV)
+30dBu
(2.45V) (24.5V)
Output level
Max. before clip
+24dBu(12.28V)
Audio
16ch input/16ch output @ 48kHz
8ch input/8ch output @ 96kHz
MAX UNITS
dBFs
dBFs
MAX UNITS
dBFs
dBFs
MAX UNITS
dBFs
dBFs
MAX UNITS
2 msec
Connector
EUROBLOCK
(5.08mm pitch)
Connector
EUROBLOCK
(5.08mm pitch)
Connector
RJ-45x2