Using The Inverter - Dometic WAECO SinePower MSI 924M Instrucciones De Montaje Y De Uso

Using the inverter

10 Using the inverter
10.1 Switching on the inverter
➤ Set the main switch (fig. 5 1, page 4) of the inverter to the "ON" position.
Set the On/Off switch to "OFF" to switch off.
➤ The inverter performs a self-test.
During the self-test, the built-in speaker emits tones and the LEDs flash.
✓ After the self-test is completed successfully, the "Input Level" (fig. 5 2,
page 4) and "Load Status" (fig. 5 3, page 4) LEDs light up green.
Observe the following when using the device (see also chapter "Trouble-
shooting" on page 46)
The inverter switches off if:
 the battery voltage drops below 21 V for 10 seconds,
 the battery voltage drops below 18 V for 0.3 seconds
 the battery voltage exceeds 32 V,
 the inverter overheats.
➤ If this happens, shut down the inverter with the main switch(fig. 5 1,
page 4).
➤ Check that the inverter is sufficiently ventilated and that the ventilation
grilles are unimpeded.
➤ Wait 5 – 10 minutes and switch the inverter on again without any electric
consumers.
After an under voltage (below 21 V) occurs the battery needs to be recharged
to keep 25 V for 3 seconds to restart the inverter.
When operating the inverter at high load for lengthy periods, it is advisable to
start the engine in order to recharge the vehicle battery.
42
MSI924M
EN