Filling/Draining The Water Tank; Steam Smoothing Clothes; Steam Smoothing Curtains And Upholstery; Stop Steam Smoothing - Silvercrest SDMF 1300 B1 Instrucciones De Utilización Y De Seguridad

˜ Steam smoothing curtains
and upholstery
Remove creases and wrinkles from curtains
and upholstery by hanging these over a
railing and then tightening them .
Before steam smoothing: Always carry out a
test on an inconspicuous piece of the fabric .
Steam the curtains/upholstery (see "Steam
smoothing clothes") .
When using the product horizontally: Hold
the product vertically from time to time to
maintain the maximum steam power .
˜ Stop steam smoothing
Move up the lock
3 ] [
.
[ 3 ]
Place the product, with its base
and stable surface .
Set the on/off switch
Disconnect the power plug
power socket .
NOTE: When
3 ] [
stops heating automatically after approx .
15 minutes . The red LED
product switches off .
Let the product cool down (for approx .
15 minutes) . Do not leave the product
unattended while it is still hot .
Empty the water tank
prevent limescale (see "Filling/draining the
water tank") .
26 GB/IE
, if applicable . Release
, on a flat
6 ] [
to the O position .
12 ] [
from the
8 ] [
is released, the product
flashes until the
11 ] [
after each use to
5 ] [
˜ Cleaning and care
DANGER! Risk of electric shock!
Before cleaning or maintaining the product:
Disconnect the power plug
power outlet .
m
WARNING! Do not immerse the product's
electrical components in water or other
liquids . Never hold the product under
running water .
Wipe down the product with a slightly damp
cloth .
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product .
Let all parts dry completely after cleaning .
˜ Descaling
Use a commercially available descaling
agent .
Mix a solution of descaling agent and water .
Fill the solution up to the MAX marking
in the water tank
5 ] [
into the product .
m
WARNING! Follow the instructions of the
descaling agent's manufacturer when mixing
the solution .
Let the solution work according to the
instructions of the descaling agent's
manufacturer .
Connect the power plug
power outlet .
Wait until the product has reached its
operating temperature (the LED
permanently) .
Let the steam escape over a sink until no
debris or dirt is left .
from the
8 ] [
7 ] [
. Insert the water tank
to a suitable
8 ] [
lights up
11 ] [