Safety Precautions; Working Clothes; Residual Risks; Allowed Use - Aprimatic EM 51 ALZO Instrucciones Para La Instalación

2.1

WORKING CLOTHES

To work in full compliance with the safety regulations:
• wear type-approved working clothes and personal
protection equipment (working shoes, protection goggles,
gloves and hard hat);
• do not wear objects that may get caught somewhere (ties,
bracelets, necklaces, etc.).
Warning
Suitably delimit the intervention area to keep non-
authorized people away.
2.2

RESIDUAL RISKS

Warning
When the gate is opening, do not put your hands or other
parts of your body close to the area where the operator
gear works. You can be injured.
2.3

ALLOWED USE

This automation has been designed to automate tilt-up doors
with counterweight provided they fall within the application
fi eld of the automation (see par. 2.3.1).
Warning
• The use of the product for purposes other than those
stated by the manufacturer is expressly forbidden.
• Do not alter or tamper the product.
• The product must be installed using original material
only.
Caution
The automation cannot be regarded as a supporting or
safety element of the door; the latter must be equipped
with adequate supporting and safety systems.
2.3.1 Application fi eld
Max door panel surface
N˚ 1 oper. Max width 3.5 m
N˚ 2 oper. Max width 5 m
Warning
The operator has been designed for application on gates of residential buildings rated for max 50 cycles a day.
3.1

TECHNICAL FEATURES

Technical features
Application
Technology
Power supply
Absorbed power
Absorbed current
Overload setting
Functioning temperature
Nominal torque
Degree of protection
Auxiliary power supply
Opening time
Safety precautions / Technical Characteristics
The installer must check that the temperature range
Max height 3 m marked on the appliance plate is suitable for the location.
Max height 3 m
Counter-weighted up-and-over doors
Electromechanical
230 V 50/60 Hz 50Hz
250 W
1,6 A
150° C
-20° / +70° C +60°C
450 Nm
IP 44
24 V dc
17 sec
- 13 -
Fig.1
Fig.2
WARNING: If the power supply cable is damaged,
it must be replaced by the manufacturer or its
technical assistance service or in any case by
a similar qualified person, in order to prevent
any risk.
Noise emitted during working process ≤70dB.
The maximum height of 2000mt of altitude must be
respected for the installation of the motor.