StetSom Bravo Full 2000 Serie Manual De Usuario página 8

Troubleshooting
AMPLIFIER DOES NOT TURN ON:
▪ Verify that the cables are connected correctly. Make sure all connections
have electrical and mechanical contact.
▪ Fuses or circuit breakers may be defective or blown. Check the condition of
the circuit breakers and make sure they are compatible with the equipment
consumption.
▪ Make sure that the battery is charged sufficiently for the product to operate.
NO SOUND:
▪ The cables to the speakers or RCA plugs may not be connected incorrectly or defective.
▪ Make sure that the LEVEL control is not at a minimum.
PROT LED FLASHING:
▪ Make sure that the product's air vents are not blocked and that the
product is not overheating.
▪ Speakers or cables are shorted. Check speakers, cables and connections.
SOUND DISTORTIONS:
▪ The speakers may be overloaded or defective, lower the level and then readjust
the level. This setting can be adjusted as follows:
a) On the radio/player, play any musical signal and set the volume to 80% of
the maximum (if the maximum volume of the radio /player is 45 (100%), set to 36
(80%).
b) On the amplifier, begin with the LEVEL control at minimum, increase
gradually until the LED CLIP starts to flash. Slowly decrease the LEVEL until the led
goes out completely.
WEAK OF BASS:
▪ Cables of the speakers may be reversed
NOISE AND FAILURE IN SOUND:
▪ Make sure that the installation is not close to the vehicle's original wiring
as it may cause interference and noise in the audio signal.
and (speakers out-of-phase).
8