Battery Operation; Remote Control Operation - Lenco SCD-720 Manual De Usuario

BATTERY INSERT
OPEN
+
C 1,5V C 1,5V
OPEN
AUX IN
+ 1,5V + 1,5V
1,5V + 1,5V +
+
C 1,5V

BATTERY OPERATION:

For DC operation, firstly remove the AC plug from the AC outlet and
disconnect the AC cord from the ~ AC IN jack. Remove the battery
compartment door at the rear of the unit. Install 6pcs UM-2 (LR14)
C size batteries (NOT supplied) according to the polarity markings
sho n inside of the compartment. Install the battery compartment
door.
Note:
- Since the unit dra s a little po er from the batteries in standby
mode, remove the batteries if the unit is not going to be used for
a long time.
- Since the unit is at po er saving status hen it is in battery stand
by mode, you can ONLY use the unit's STANDBY button by press
and hold it more than 5 seconds to turn on the unit. To turn off,
press the STANDBY button again.

REMOTE CONTROL OPERATION:

A CR2025 battery is already installed in the remote control unit.
Before using, pull out the battery insulation sheet as sho n on the
left.
To replace a ne battery, please refer to the figure sho n on the left.
When inserting a battery, be sure to do so in the proper direction.
-8-
+ 1,5V
~AC IN
1,5V +