Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
11 Using the Pole Pruner
11.1
Holding and Controlling the
Pole Pruner
► Hold the pole pruner by the control handle with
one hand – wrap your thumb around the con‐
trol handle.
► Hold the pole pruner firmly with your other
hand by the handle hose – wrap your thumb
around the handle hose.
11.2
Delimbing
Cross-cut
► Place the guide bar on the branch as shown.
► With the chain running at full speed, pivot the
guide bar downward against the limb.
► Cut through the limb with the bottom of the
guide bar.
2
► If the limb is under tension: Make the relieving
cut (1) at the compression side and then per‐
form the bucking cut (2) from the tension side.
40
Cutting thick branches
► Perform a relieving cut (2) at cutting point (2)
► Perform a relieving cut and then finish with a
12.1
► Switch off the pole pruner and remove the bat‐
► If the pole pruner is wet: Allow the pole pruner
► If the battery is wet: Leave the battery to dry.
► Clean the pole pruner.
► Clean the guide bar and saw chain.
► Loosen the nut on the chain sprocket cover.
► Back off the tensioning screw 2 turns counter‐
► Tighten down the nut on the chain sprocket
► Fit the chain scabbard so that it completely
► Clean the battery.
13.1
► Switch off the pole pruner and remove the bat‐
► Fit the chain scabbard so that it completely
1
Carrying the pole pruner
► Carry the pole pruner in one hand by the shaft
Transporting the pole pruner in the car
► Remove the shaft.
► Secure the pole pruner to prevent tipping over
13.2
► Switch off the pole pruner and remove the bat‐
1
at a distance a = 20 cm from the final cross cut
(1).
cross-cut (1).
12 After Finishing Work
When Work is Finished
tery.
to dry.
clockwise.
The saw chain is now slack.
cover.
covers the guide bar.
13 Transporting
Transporting the Pole Pruner
tery.
covers the guide bar.
with the guide bar behind you.
and movement.
Transporting the Battery
tery.
11 Using the Pole Pruner
a
2
0458-813-9821-A
Tabla de contenido
