Troubleshooting; Specifications - TCL Breeva A2W Manual Del Usuario

Troubleshooting

The following lists the problems you may encounter during use. If you cannot
solve the problem based on the information below, please contact your local
dealer.
Problems
The red indicator on the
panel flashes for a long time.
No air is discharged from
the air outlet.
The product has been
running for a long time, and
the air quality has not
improved significantly.
Difficult to remove dirt in
the air.
The wind blowing from the
air outlet has a peculiar
smell.
No response after touching
buttons.
The water tank cannot be
turned on after adding
water.

Specifications

Product model
Rated voltage
Rated power
Clean air delivery rate (CADR)
Applicable area
You ignored the reminder to replace the filter. When the red indicator on the panel
starts to flash, you did not replace the filter in time; You must replace the filter and
press and hold the light button for 3 seconds. After the reset is complete, the indicator
goes out.
The product is not connected to the power source. Please insert the plug into the
power socket and turn on the product.
A certain filter may not be placed as it should inside the product. Please make sure to
install the filter in the correct order, starting with the innermost filter: composite
filter-base.
The indoor humidity is too high, so condensate is formed. Do not place the product in
a place with high humidity such as bathroom, toilet
There are obstacles around the product that affect the purification effect. (Refer to the
instructions for use.)
The room where the product is in is too large. The recommended room area for this
product is about 182 square feet.
Is the filter dirty? If there is no improvement after maintenance, please replace the
filter.
Is it used in places with strong smells? If you use it under strong odors such as
cigarettes and barbecues, the filter will produce an unpleasant odor within weeks or
months. Please replace the filter and keep it well ventilated.
Please confirm whether the child lock button is locked first, you need to press and
hold the child lock button for 3 seconds to unlock the child lock button, and then
touch other buttons to operate.
Please check if the air outlet switch has been pressed in place.
Breeva A2W
Breeva A2WK
- 14 -
Possible solutions
Breeva A2WW Breeva A2B
Breeva A2WWK Breeva A2BK
24V
26W
117 cfm
200 m³/h
14~24㎡
Breeva A2BW
Breeva A2BWK