Installation; Before You Start - Cooke & Lewis CLCER65 Manual Del Usuario

Installation

EN

Before you start

Caution: The ceramic hob must be
installed by qualified personnel or
technicians. Please never conduct the operation by yourself.
• The hob must not be installed directly above a
dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the
hob electronics.
• Do not attempt to dismantle the appliance,
there are no user servicable parts inside.
• At the end of its life, the appliance should not be
disposed of in household waste; contact your
Local Authority for guidance.
Caution: This hob must be connected
to the mains power supply only by a
suitably qualified person.
• Before connecting the hob to the mains power
supply, check that:
- The domestic wiring system is suitable for
the power drawn by the hob.
- The voltage corresponds to the value given in
the rating plate.
- The power supply cable sections can
withstand the load specified on the rating
plate.
- To connect the hob to the mains power
supply, do not use adapters, reducers,
or branching devices, as they can cause
overheating and fire.
- The power supply cable must not touch any
hot parts and must be positioned so that its
temperature will not exceed 75˚C at any point.
- The work surface is square and level, and
no structural members interfere with space
requirements.
- The work surface is made of a heat-resistant
material.
- If the hob is installed above an oven, the oven
has a built-in cooling fan.
- The installation will comply with all clearance
requirements and applicable standards and
regulations. The permanent wiring, mounted
and positioned to comply with the local wiring
rules and regulations.
211859_s1_s7-5059340158013-C&L-A5-IM-Easy-V01-Multi.indd 4 211859_s1_s7-5059340158013-C&L-A5-IM-Easy-V01-Multi.indd 4
- The isolating switch must be of an approved
type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for
this variation of the requirements).
- The isolating switch will be easily accessible
to the customer with the hob installed.
• You consult local building authorities and by-
laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean
finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
• When you have installed the hob, make sure
that: The power supply cable is not accessible
through cupboard doors or drawers.
• There is adequate flow of fresh air from outside
the cabinetry to the base of the hob.
• If the hob is installed above a drawer or
cupboard space, a thermal protection barrier is
installed below the base of the hob.
• The isolating switch is easily accessible by the
customer.
• The hob should be fixed into the worktop using
the fixing brackets with the supplied assembling
screws. This hob must not be sealed into the
worktop, doing so will prevent an engineer
removing the appliance to facilitate a repair.
04
08-01-2021 09:58:57 08-01-2021 09:58:57