Power On & Reset; Alarm Setting - Daewoo DCD-220 Manual De Instrucciones

POWER ON & RESET
Insert 3xAAA batteries into the battery compartment following the correct polarity. Do
not mix new and old batteries. Do not mix alkaline, standard (carbon-zinc), or recharge-
able (nickel cadmium) batteries.
The display will light up and the bell will ring for 5 seconds!.
NOTE: The upper battery gives power for the bell ringing and the two lower batteries
for the clock settings. If the clock does not ring but the display is working please check
if the upper battery is fi nished, replace it.
CLOCK TIME SETTING
• Hold "set" key to enter into time and date setting mode. When setting, the fi gure
to be set will be fl ashing.
• The setting sequence is: Year -> Month -> Date -> Hour -> Minute -> 12H\24H ->
exit.
• Click "UP" or "DOWN" key one time, the setting value will go forward for one step;
hold the key for 2 seconds, it will run forward by 8 steps/second.
• If no key is operated longer than 30 seconds, the system will exit setting mode
automatically and save the set data.
• 12H\24H set: under setting 12H\24H status press down and up key to switch
12H\24H.

ALARM SETTING

• Hold "UP/AL1 SET" to enter into ALARM 1 setting mode.
• When setting, the fi gure to be set will be fl ashing.
• The setting sequence is: M-F S-S -> M-F -> S-S -> Hour -> minutes -> exit
• "M-F"to set the alarm time only from Monday to Friday
• "S-S" to set the alarm time only from Saturday to Sunday
• "M-F" & "S-S"to set the alarm all the days of the week
• • Click "UP" or "DOWN" key one time, the setting value will go forward for one step;
hold the key for 2 seconds, it will run forward by 8 steps/second
• • If no key is operated longer than 30 seconds the system will exit setting mode
automatically and save the set data.
• • Hold "DOWN/AL2 SET" key enter into ALARM 2 setting mode, others same as
ALARM1 setting.
ACTIVATE/ DEACTIVATE THE ALARM AND SNOOZE
• Move the right switch ALM1 to ON to activate the alarm 1 or to OFF to deactivate it.
• Move the left switch ALM2 to OFF to activate the alarm 2 or to OFF to deactivate it.
ENG
4