Unit Operation - Fracarro KDTR Instrucciones De Uso

keep all modules separated at an equal distance. The output signal is already filtered and amplified
with a variable level (adjustable by a step of 1 dB by the TPE programmer).
SUMMARY OF THE RANGE:
MODEL MODULATOR TYPE
KDTR OFDM receiver with VSB E2-E69 modulator, PAL B/G standard, audio mono
KDTR-S OFDM receiver with VSB E2-E69 modulator, PAL B/G standard, audio stereo
KDTR-M OFDM receiver with VSB E2-E69 modulator, multi-standard (PAL I, N, H,...)
KDTR-AV OFDM receiver with A/V outputs on RCA connector
Connect the receiver to a KP K series feeder and wait until the green LED starts to fl ash; this means
that the module reset (bootstrap) is completed and the module is ready to be used; connect TPE.
Summary table of the LEDs status:
LED status
Red LED
Fixed green LED
Flashing green LED
Green LED Off
To program and display the internal state of KDTRs, use the TPE universal programmer. Connect the
programmer to the RJ45 outlet on the module front panel; TPE will switch on automatically.
The following are the programming menus of KDTRs:
SETTING THE INPUT
PARAMETERS (SEE 1.0)
SETTING THE OUTPUT
PARAMETERS (SEE 2.0)
MEASURES RELEVANT TO
THE INPUT SIGNAL (SEE 3.0)
Attention: It is also possible to set the TPE language in the TPE SETUP
Press or any keys.

UNIT OPERATION

Reason
Module in error. To restore the proper operation, disconnect and reconnect the power
cable. Contact the nearest assistance centre if the problem continues.
The receiver is working properly, the multiplex is received correctly, and the front-end
and MPEG decoder are both working properly
The receiver is not detected
- the receiver is not power supplied
- the module is broken
- the module is booting up (wait a few seconds)
PROGRAMMING THE MODULE
INITIAL MENU - KDTR
INPUT
OUTPUT
MEASURES
THE KEY IS USED TO CONFIRM AN ENTERED
VALUE OR TO ENTER A MENU.
THE KEY IS USED TO CANCEL AN ENTERED
VALUE OR TO EXIT FROM A MENU
S
THE KEY IS USED TO SAVE CHANGES
ARROW KEYS ARE USED TO SCROLL
THROUGH THE MENU ITEMS
NUMERIC KEYS ARE USED TO ENTER VALUES
10
LANGUAGE menu.