Care And Cleaning; Defrosting The Freezer; Changing The Light; Availability Of Spare Parts - Fulgor Milano FBR 300 F ED Manual De Usuario

Always disconnect the appliance from the power
supply before any cleaning or maintenance.
The fridge and crisper sections should be cleaned using a
solution of bicarbonate of soda and lukewarm water. Do not
use abrasive products or detergents. After washing, rinse and
dry thoroughly.
Clean the shelves, drawers and balconies separately by hand
with a mild solution of washing up liquid and water. Do not put
them in the dishwasher.
The water drain hole at the back of the fridge compartment
should be cleaned periodically to prevent the defrosted water
from collecting inside the fridge compartment. The drain plug
can be used to clean the drain hole.
If the appliance is not to be used for prolonged periods of
time, unplug and clean the appliance. The doors should be left
slightly ajar to prevent the formation of mildew and unpleasant
odors.
Fig. 4
Drain Plug
Drain hole

Defrosting the freezer

The fridge is self-defrosting. Any water created will
run out of the fridge through the channel at the
back of the fridge, unless the drain hole is blocked.
It is important to keep the channel clear at all times
using the cleaning tool/drain plug supplied. The
defrosted water is collected in the evaporating
tray at the back of the appliance and dissipated by
evaporation.
Please note: If you are regularly finding pools of water
in the fridge, or you notice that the compressor is always
running, then it is likely that the door is not sealing properly.
This could be due to a defective door seal or an incorrectly
fitted, or overly heavy, decor door. For more information see
the troubleshooting section.

Changing the light

If the LED lighting fails in any way, it should only be replaced
by authorized service agents. In the event of light failure within
your fridge please contact Customer Care to arrange a service
visit. Contact details are on the rear cover of this manual.

5 - Care and cleaning

Availability of spare parts

• Thermostats, temperature sensors, printed circuit boards
and light sources are available for a minimum period of
seven years after placing the last unit of the model on the
market.
• Door handles, door hinges, trays and baskets for a minimum
period of seven years and door gaskets for a minimum
period of 10 year, after placing the last unit of the model
on the market.
EN
9