Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank
begins to build. It builds to a certain high pressure before the motor automatically shuts off, protecting
your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called
"cut-out" pressure.
Branch Circuit: Circuit carrying electricity from electrical panel to outlet.
This air compressor pump is capable of running continuously. However, to prolong the life of your air
compressor, it is recommended that a 50%-75% average duty cycle be maintained; that is, the air
compressor pump should not run more than 30-45 minutes in any given hour.
UNPACKING
Remove unit from carton and discard all packaging.
HOW TO SET UP YOUR UNIT
LOCATION OF THE AIR COMPRESSOR
•
Locate the air compressor in a clean, dry and well ventilated area.
•
The air compressor should be located at least 12" (30.5 cm) away from the wall or other obstructions
that will interfere with the flow of air.
•
The air compressor pump and shroud are designed to allow for proper cooling. The ventilation
openings on the compressor are necessary to maintain proper operating temperature. Do not place
rags or other containers on or near these openings.
GROUNDING INSTRUCTIONS (FIG. 1)
RISK OF ELECTRICAL SHOCK. In the event of a short circuit, grounding
reduces the risk of shock by providing an escape wire for the electric current. This air
compressor must be properly grounded.
The portable air compressor is equipped with a cord
having a grounding wire with an appropriate grounding
plug (A).
1.
The cord set and plug (A) with this unit contains a
grounding pin (B). This plug MUST be used with a
grounded outlet (C).
IMPORTANT: The outlet being used must be installed
and grounded in accordance with all local codes and
ordinances.
2.
Make sure the outlet being used has the same
configuration as the grounded plug. DO NOT USE AN ADAPTER. See figure 1.
3.
Inspect the plug and cord before each use. Do not use if there are signs of damage.
4.
If these grounding instructions are not completely understood, or if in doubt as to whether the
compressor is properly grounded, have the installation checked by a qualified electrician.
RISK OF ELECTRICAL SHOCK. IMPROPER GROUNDING CAN RESULT IN
ELECTRICAL SHOCK.
Do not modify the plug provided. If it does not fit the available outlet, a correct outlet should
be installed by a qualified electrician.
Repairs to the cord set or plug MUST be made by a qualified electrician.
DUTY CYCLE
ASSEMBLY
INSTALLATION
FIG. 1
A
B
7 - ENG
C
Tabla de contenido
