Introduction; 1�1 Symbols Used; Safety; 2�1 Intended Use - Renfert POWER steamer water softener Manual De Instrucciones

1

Introduction

1.1 Symbols used
Symbols with the following meanings are used in these instructions or on the equipment:
Danger
Immediate danger of injury. Consult accompanying documents!
Electrical current
Danger due to electrical current.
Caution
Risk of damage to the equipment if the instruction is not followed.
Notice
Provides the operator with useful information that eases use.
The equipment complies with applicable EU directives.
The equipment is subject to the provisions of the EU directive 2002/96/EC (WEEE directive).
► List, particular attention should be paid
• List
- Subordinate list
⇒ Instructions / appropriate action / input / operational sequence:
You are asked to carry out the specified action in the order indicated.
♦ Result of an action / response by the equipment / response by the program:
The equipment or program responds as a result of your actions or when a specific incident occurs.
Other symbols are explained as they occur�
2

Safety

2.1 Intended use
The POWER steamer water softener is looped in between the water connection and the
POWER steamer 2�
2.2 Improper use
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
equipment, increase the risk of serious injury and lead to damage to the environment or the product itself�
2.3 Ambient conditions for storage and transport
The following ambient conditions must be observed during storage and transport:
• Ambient temperature of -15 – +45 ºC [-4 – +140 ºF]
• Maximum relative humidity 80 %
2.4 Hazard and warning information
2.4.1 General information
► If the unit is not used in accordance with the supplied operating instructions, the intended safety
can no longer be guaranteed.
► Check connection cables (such as power cords), tubes and housing (such as the key pad) regu-
larly for damage (such as kinks, cracks and porosity) or signs of ageing.
Do not operate equipment with damaged connection cables, tubes or housing parts or other de-
fects!
► Only operate the equipment under supervision.
► Please observe the national accident prevention regulations!
► Information on REACH and SVHC is available on our website at www.renfert.com, in the Support
area.
- 3 -
en