Working Position - Black and Decker TR116 Manual De Instrucciones

TRIMMING INSTRUCTIONS
1. EXTENSION CORD – (Figure
E) Always keep extension cord
behind trimmer and away from the
trimming operation. Never drape
it over a hedge being trimmed.
If you cut or damage the cord,
unplug it at the electrical outlet
immediately, before inspecting or
repairing cord.
2. WORKING POSITION – Maintain
proper footing and balance and
do not overreach. Wear safety
goggles, non-skid footwear and
rubber gloves when trimming. Hold the tool firmly in both hands
and turn the tool ON. Always hold the trimmer, as shown in
figure E, with one hand on the switch handle and one hand on
the auxiliary handle. Never hold the tool by the blade guard.
3. TRIMMING NEW GROWTH - (Figure
F) – A wide, sweeping motion,
feeding the blade teeth through
the twigs is most effective. A slight
downward tilt of the blade, in the
direction of motion gives the best
cutting.
CAUTION:
Do not use trimmer for cutting stems greater than
5/8 in. (16mm). Use the trimmer only for cutting normal shrubbery
found around houses and buildings.
All manuals and user guides at all-guides.com
E
F
0-15
4. LEVEL HEDGES (Figure G) – To
obtain exceptionally level hedges,
a piece of string can be stretched
along the length of the hedge as a
guide.
5. SIDE-TRIMMING HEDGES
(Figure H) – Begin at the bottom and
sweep up.
WARNING:
TO GUARD AGAINST
INJURY, OBSERVE THE FOLLOWING:
• READ INSTRUCTION MANUAL
BEFORE USING, SAVE
INSTRUCTION MANUAL.
• CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH AS
WIRE OR FENCES BEFORE EACH USE.
• KEEP HANDS ON HANDLES. DON'T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
• DO NOT USE WITH DAMAGED EXTENSION CORD.
DANGER:
KEEP HANDS AWAY FROM BLADES.
CAUTION:
BLADE COASTS AFTER TURN OFF.
6
G
H