Dometic WAECO MagicWatch MWE910 Instrucciones De Montaje Y De Uso página 26

Instructions before installation
Note the following during installation:
 The distance from the sensors to the ground should be between 40 cm
and a maximum of 60 cm (fig. 3).
 For the sensors to function optimally, the angle of the sensor to the road
surface should be 90° (fig. 3). The angle may not be less than 90°, as
the road will otherwise be interpreted by the sensor as an obstacle.
 The sensor holders included are suitable for all standard bumpers. Should
the vehicle bumper be mounted at a steep angle, 20° sensor holders with
a cover ring are available as an optional extra (see chapter "Accessories"
on page 23).
 The sensor holders included are not suitable for installation in metal
bumpers. If your vehicle has metal bumpers, you will need special sensor
holders with a silicon ring (see chapter "Accessories" on page 23).
 Note that the sensor holder depends on the installation height and the an-
gle of the bumper. Select the right sensor holder and the appropriate drill
diameter by consulting the table in fig. 3. The instruction manual shows
how to install the standard sensor holder (fitted from the inside of the
bumper), which produces the best visual result. Alternatively, the sensors
can also be fitted using the sensor holders with cover ring which are pro-
vided.
 Install the sensors in the correct place (fig. 6):
Colour of sensor
Blue (bl)
Black (sw)
Green (gn)
4.2 Painting the sensors
See fig. 2
NOTE
I
The sensors may be painted. The manufacturer recommends
having the sensors painted by a specialist workshop.
24
All manuals and user guides at all-guides.com
Installation location
Outer sides of the rear bumper
Centre of the rear bumper
Front bumper
MagicWatch MWE910, 900, 900F
EN