Maintenance - Husky ST80 Guía De Uso Y Cuidado

Operation Instruction
3
Setting Up for Lift TIG Welding
□ Connect the ground clamp cable to the positive (+) DINSE
socket (F) of the welder.
□
Ensure your workpiece is clean and dry and the ground
clamp has a good connection to the workpiece.
□
Connect the TIG torch cable to the negative (-) DINSE
socket (E) of the welder.
□
Connect the TIG torch gas line to the gas regulator of a gas
tank (argon gas only).
□
Install the tungsten electrode into the TIG torch, and keep
approximately 1/4 inch out of the torch nozzle.
□
Switch the ON/OFF switch (G) to ON at the back of the
machine.
□
Push the welding mode switch button (D) until TIG mode
LED turns on.
□
Set the amperage by rotating the amperage adjustment
knob (C).
□
Open the gas valve on the TIG torch.
□
The weld arc can be initiated by a lift arc technique.
□
When finished welding, close the gas valve on the TIG
torch.
□
When all welding completed, close gas valve on the gas
cylinder.

Maintenance

□
Before each use, inspect the general condition of the welder. Check for loose screws, cracked or broken parts, damaged circuit
wiring or cables, and any other potential risks that may cause safety issues. Replace damaged or worn parts, cords/cables or gun
assembly.
□
After each use of the welder, clean external surfaces of the welder with clean cloth.
□
Periodically clean the welder using compressed air to blow out all dust and debris from the interior.
□
If the unit continuously shuts down due to thermal overload, please turn off the welder and have a qualified electrician inspect the
welder and repair it.
□
Store the welder and accessories in a clean and dry location out of reach of children.
Lift TIG Welding Recommendation Table
Material Tungsten (Ce) Diameter
1/16 in. (1.6 mm)
Steel,
Stainless
Steel
5/64 in. (2.0 mm)
Cannot weld aluminum.
Recommended shielding gas: argon.
9
Please contact 1-888-43-HUSKY for further assistance.
Amp
10-80A
10-80A
HUSKYTOOLS.COM