Control Panel; Rear Part; Installation - Selecta PLACTRONIC 6155100 Manual De Instrucciones

MANUAL DE INSTRUCCIONES CODIGO 80064 REV D JUN-2007
1 2
9 3 4
10
J
.P. SELECTA s.a.
5 8

6.3 Control panel

1. Temperature and time display
2. Temperature set indication led
3. Time set indication led 4. Modification set key
5. Increasing value key
6. Decreasing value key
7. Start/Stop key
8. Overtemperature pilot lamp indicator
9. Main switch
6 7

6.4 Rear part

10. Fuse carrier
11. Power supply cord
11

7 Installation

7.1 PLACEMENT
Place the piece of equipment near of a socket keeping in mind the its amperage
on a leveled surface enough resistant to support the weight indicated on the
table of the section 3 (Technical features), leaving and space of 10 cm by the
rear part and both laterals.
NO INSTALAR EL APARATO EN ATMOSFERAS EXPLOSIVAS O EN LUGARES DONDE
SE USEN O ALMACENEN DISOLVENTES U OTROS PRODUCTOS SUSCEPTIBLES DE
FORMAR MEZCLAS EXPLOSIVAS O INFLAMABLES.
7.2 POWER SUPPLY CONEXION
Make sure that the voltage of given by the socket is the indicated on the feature
label attached on the rear part .
Do not use the equipment unless it is correctly earthed.
Be careful with the plate surface because its surface may produce burnings even
the hotplate be switched off.
If you replace the plug keep in mind the following:
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta @jpselecta.es - website: http://www.jpselecta.es
(Sujetas a modificaciones sin previo aviso)
Blue wire:
Brown wire:
Yellow/green wire:
Neutral
Phase
Ground
Tel 34 937 700 877 Fax 34 937 702 362
Pag.: 14