Tabla de contenido
Idiomas disponibles
Idiomas disponibles
gb
TOOL CHANGE
The SDS-PLUS tool holder allows for simple and
SDS
convenient changing of drilling tools without the
PLUS
use of additional tools.
Due to their working principle, SDS-PLUS drilling tools
move freely. This results in radial runout at no-load.
However, this has no effect on the accuracy of the drill
hole, as the drill bit centres itself during drilling.
The SDS-PLUS tool holder can also accommodate
different drill-bit types with hexagon shank. For more
information, see the accessories page at the end of
these operating instructions.
The dust protection cap 2 largely prevents the entry of
drilling dust into the tool holder during operation. When
inserting the tool, take care that the dust protection
cap 2 is not damaged.
A damaged dust protection cap should be
changed
having this carried out by an after-sales
service.
Inserting SDS-PLUS Drilling Tools
Clean and lightly grease the shank end of the tool.
Insert the tool in a twisting manner into the tool holder
until it latches itself.
Check the latching by pulling the tool.
Removing SDS-PLUS Drilling Tools
Push back the locking sleeve 3 and remove the tool.
5_MAINTENANCE AND SERVICE
INSTRUCTIONS
For safe and proper working, always keep
the machine and ventilation slots clean.
Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the
rotational direction switch to the centre
position. Unintentional actuation of the On/Off
switch can lead to injuries.
A damaged dust protection cap should be
changed immediately. We recommend having
this carried out by an after-sales service.
CLEANING
When the battery is no longer operative, please refer
to an authorised after-sales service agent for STAYER
power tools.
immediately.
We
recommend
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
STAYER power tools.
In all correspondence and spare parts order, please
always include the 10-digit article number given on the
type plate of the machine.
REPAIR SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information
on spare parts can also be found under:
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
WARRANTY
Warranty card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You
should fill out the card completely and return to vendor
with a copy of purchasing receipt or invoice and you
should receive a receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your
supplier.
The warranty is limited only to manufacturing
defects and expire if pieces have been removed or
manipulated or repaired other than the manufacturer.
TRANSPORT
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further re-
quirements. When being transported by third parties
(e.g.: air transport or forwarding agency), special re-
quirements on packaging and labelling must be obser-
ved. For preparation of the item being shipped, con-
sulting an expert for hazardous material is required.
Dispatch batteries only when the housing is undama-
ged. Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move around
in the packaging. Please also observe possibly more
detailed national regulations.
DISPOSAL AND RECYCLING
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste!
-
24
-
Tabla de contenido
