Standard Accessories; Maintenance And Inspection - HIKOKI D 6SH Instrucciones De Montaje

English
Switching OFF
Lock
Switch locks to the "ON" position.
Disconnect mains plug from electrical outlet
Class II tool
SPECIFICATIONS
Model
Voltage*
1
Power input*
1
No load speed
Steel
Capacity
Wood
Weight (without cord)*
2
Spec. for keyed chuck
Spec. for keyless chuck
*1 Be sure to check the nameplate on product as it is subject to change by areas.
*2 According to EPTA-Procedure 01/2014.
NOTE
Due to HiKOKI's continuing program of research and development, the specifi cations herein are subject to change
without prior notice.
MOUNTING AND OPERATION
Action
Mounting stopper assembly
Mounting and dismounting the bit*
Switch operation
Locking-on the On / Off switch
Releasing the On / Off switch
Selecting accessories
*1 Selecting the appropriate drill bit
(1) When drilling holes in metals or plastics:
Use ordinary metalworking drill bits;
Applicable drill sizes range from 0.5 mm min. to 6.5 mm
max.
(2) When drilling holes in lumber:
Use woodworking drill bits.
For small holes of 6.5 mm dia, or less, use metalworking
drill bits.
Figure Page
1 51
2 51
1
3 51
4 51
5 51
― 53

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed in the below.
(1) Chuck Wrench (Spec. only for keyed chuck) ............. 1
(2) Stopper Ass'y (Spec. only for keyed chuck) ............... 1
(3) Hook .......................................................................... 1
Standard accessories are subject to change without notice.
APPLICATIONS
Drilling in metal, lumber and plastics.
D6SH
(110 V, 220 V, 230 V, 240 V)
240 W
4500 min
6.5 mm
9 mm
0.9 kg
1.0 kg

MAINTENANCE AND INSPECTION

CAUTION
Be sure to switch power OFF and disconnect the plug
from the receptacle during maintenance and inspection.
1. Inspecting the drill bits
Since use of an abraded drill bits will cause motor
malfunctioning and degraded effi ciency, replace the drill
bits with a new one or resharpening without delay when
abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Servicing
Consult an authorized Service Center in the event of
power tool failure.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee HiKOKI power tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the power tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
4
-1