Intended Use; Led Indicators - Hilti B 3600 Manual De Instrucciones

▶ Make sure that product and consumer are both switched off before you connect the consumer. Always
switch the consumer off after use.
▶ Do not use the product to power life-supporting medical devices.
▶ If the product is too hot to touch, it may be defective. Put the product in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow it to cool
down. If the product is still too hot to touch after an hour, it is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2

Intended use

The product described is a portable energy system. It is designed for powering corded consumers.
3.3 Items supplied
Portable energy system, charging cord, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4

LED indicators

The Hilti B 3600 energy system can indicate the state of charge and fault messages.
If fault messages are detected the LEDs show or flash in accordance with the current state of charge.
Status
Eight (8) LEDs show constantly green
Seven (7) LEDs show constantly green.
Six (6) LEDs show constantly green.
Five (5) LEDs show constantly green.
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
*2345499*
1
2345499
Frames
@
Grip
;
Rotary switch
=
AC output
%
LED indicator
&
AC charging input
(
Fuse cap
)
Meaning
State of charge: 100 % to 88 %
State of charge: 87 % to 76 %
State of charge: 75 % to 63 %
State of charge: 62 % to 50 %
State of charge: 49 % to 37 %
State of charge: 36 % to 25 %
English 11